Section 5: Maintenance (Continued) - Vanair AIR N ARC I 300 SERIES Operation Manual

®
AIR N ARC I-300 SERIES ALL-IN-ONE POWER SYSTEM
G
KEY DESCRIPTION
A TENSIONER PLATE MOUNTING
AND ADJUSTMENT BOLTS
B IDLER
C TENSIONER PLATE
D TENSIONING HOLE
If necessary, order Replacement Compressor Serpentine Belt no. DR27584 (refer to Section 5.4.3 for compressor belt
replacement). For Generator / Hydraulic Pump Belt replacement refer to Section 5.4.3.4.
G
To "B"
KEY
A CLUTCH RETAINING CABLE ASSEMBLY
B ELECTRICAL HARNESS CABLE CONNECTION AT CLUTCH
C CLUTCH
D RETAINING CABLE BOLT
E LOCK WASHER
I
Electrical connection wire is zip-tied to clamp; it is not necessary to remove this zip-tie when releasing the retaining cable.
Order Compressor Serpentine Belt Replacement no. DR27584. For Generator / Hydraulic Pump Belt replacement refer to
Section 5.4.3.4.
E
KEY
E Loosen bolts [A] to allow tensioner plate to pivot manually to achieve
new belt-tensioned position.
F Pivot plate by applying 40 ft-lbs. torque wrench to tensioning hole.
G Belt tension adjustment should be verified using a tension tester.
Figure 5-3: Compressor Serpentine Belt Re-tensioning
C
D
E
F
H
J
DESCRIPTION
Figure 5-4: Clutch Access for Belt Removal
090045-OP_r1
®
F
DESCRIPTION
A
KEY
F WASHER
G
HARNESS CABLE CLAMP
H CLUTCH RETAINING CABLE
J CABLE CONNECTION HOLE
SECTION 5: MAINTENANCE
A
B C D
C
B
DESCRIPTION
I
PAGE - 47