Overheating Can Damage Motors; Flying Sparks Can Cause Injury; Overuse Can Cause Overheating; Enclosed Spaces Can Cause A Build-Up Of Noxious Fumes And Overheating - Vanair AIR N ARC I 300 SERIES Operation Manual

SECTION 1: SAFETY
1.7.16 WEAR PROPER PROTECTIVE
EQUIPMENT
Wear the proper protective
clothing
servicing or maintaining the
hydraulic system or the Vanair
pump.
protective gear, safety glasses,
gloves, and safety shoes. Serious injury can
result without proper protective gear.
1.7.17 KEEP CLEAR OF MOVING
PARTS
Make sure to keep hands and
feet and other parts of your
body clear
moving parts. Failure to comply
can cause serious injury.
1.7.18 CONFINE LOOSE CLOTHING
AND HAIR; REMOVE WATCHES,
RINGS OR JEWELRY DURING
OPERATION
DO NOT wear watches, rings, or jewelry
while working with electrical and mechanical
equipment. These items can be hazardous
and can cause serious and painful injuries if
they come into contact with electrical wires,
moving parts, or hydraulic equipment.
1.8 ADDITIONAL SYMBOLS FOR
INSTALLATION, OPERATION
AND MAINTENANCE
1.8.1 FALLING UNIT CAN CAUSE
INJURY
Use lifting bail to lift unit and
properly installed accessories
only.
Lift and support unit only with
proper equipment and correct
procedures.
PAGE - 10
AIR N ARC
when operating,
Wear the correct
of revolving or
090045-OP_r1
®
I-300 SERIES ALL-IN-ONE POWER SYSTEM
If using lift forks to move unit, be sure forks
are long enough to extend beyond opposite
side of unit.
1.8.2 OVERHEATING CAN DAMAGE
MOTORS
Turn off or unplug equipment
before
engine.
DO NOT let low voltage and
frequency caused by low engine speed
damage electric motors.
1.8.3 FLYING SPARKS CAN CAUSE
INJURY
Wear a face shield to protect
eyes and face.
Shape tungsten electrode only
on grinder with proper guards
in a safe location wearing
proper face, hand, and body protection.
Sparks can cause fires—keep flammables
away.
1.8.4 OVERUSE CAN CAUSE
OVERHEATING
Allow cooling period; follow
rated duty cycle.
Reduce current or reduce
duty cycle before starting to
weld again.
DO NOT block or filter airflow to unit.
1.8.5 ENCLOSED SPACES CAN
CAUSE A BUILD-UP OF NOXIOUS
FUMES AND OVERHEATING
starting or stopping
DO NOT use in enclosed
spaces where deadly
exhaust gasses can build
up and machine can
overheat, causing fire.
®