Table of Contents
Advertisement
Menu Screen (Recording Mode)
1
2
3
.
1
Up/Down Arrow Keys
Moves the cursor upward or downward.
0
2
Set Button
Confirms the selected item.
0
3
Previous Button
Returns to the previous screen.
0
4
Power Off Button
Pressing the button for approximately 2 seconds or longer turns off
0
the power.
5
STATUS Screen Display Button
Displays the screen for check the current settings.
0
6
Close Button
Exit the menu.
0
Configuring the Initial Settings
6
When the power of this unit is turned on for the first time, it is necessary to
select a display language and configure the internal clock for the initial
settings. All operations are disabled until initial settings are configured.
5
1
Open the LCD monitor.
4
The power turns on, and a language selection screen appears.
0
2
Configure the language to use.
Tap 3 or 2 to select the language to use, followed by tapping "SET".
0
Memo :
The Language screen appears when the power of this unit is turned on for
0
the first time, or when "System"F"FACTORY PRESET" is executed from
the menu.
The menus and messages on the LCD screen are displayed in the
0
selected language.
3
Set the time zone and date/time.
Move the cursor with 0 1 to select an item.
0
Use 32 to change the setting.
0
Memo :
The Initial Settings screen appears when the power of this unit is turned
0
on for the first time, or when the unit is powered on again about a month
after the battery ran out.
Even when the power is turned off, the configured date/time data is stored
0
using the built-in battery.
4
After the settings are configured, tap "SET" according to the time signal.
The clock is set to 0 seconds of the date and time entered.
0
Memo :
The configured date/time data can be displayed on the LCD screen or
0
recorded to an SD card.
The value of the year can be set in the range of "2000" to "2099".
0
.
Language
English
Français
Deutsch
Español
Italiano
Nederlands
Language
.
Initial Setting
UTC
-
-
.
Getting Started
:
-
13
Advertisement
Table of Contents
