Table of Contents
Advertisement
Troubleshooting
Power supply
Unable to turn on the power.
Check whether the AC adapter is properly connected.
0
See "Charging" (A p. 6) .
When the unit does not turn on even after charging, reset the unit.
0
"When the unit is not working properly" (A p. 131)
132
Recording
Recording cannot be performed.
Check whether the inserted SD card supports the current recording
0
format.
Check whether the Write Protect switch of the SD card is set to "LOCK".
0
Set to the recording mode by tapping the E button on the screen.
0
Recording stops automatically.
Recording stops automatically as it cannot be performed for 12 or more
0
consecutive hours according to specifications. (It may take some time to
resume recording.)
Turn off this unit, wait for a while, and turn it on again. (This unit stops
0
automatically to protect the circuit when the temperature rises.)
The focus is not adjusted automatically.
If you are recording in a dark place or a subject that has no contrast
0
between dark and light, adjust the focus manually.
"Adjusting Focus Manually (FOCUS)" (A p. 23)
Wipe the lens with a lens cleaning cloth.
0
Cancel manual focus on the manual recording menu.
0
"Adjusting Focus Manually (FOCUS)" (A p. 23)
The inside of the lens is foggy.
Open the terminal cover; close the LCD monitor and leave as is for a while
0
to reduce the temperature.
Preventing fogging inside the lens
Models with waterproof function are airtight. When the temperature rises
0
during recording, condensation can occur inside the lens due to the
internal humidity.
During recording
o
To prevent the temperature of this unit from rising, we recommend that
0
you use the unit in the following ways.
A Avoid frequent exposure to direct sunlight.
Record under the shade or use an umbrella. Best if you could keep a
wet towel cover the unit.
B The use of a tripod is recommended.
Long hours of recording while holding the unit in your hands will cause
the temperature of the unit to rise.
C It is better to leave the terminal cover open while recording.
However, the waterproof, dust-proof and shockproof features do not
function in this condition. Do take note of the environment when using
the camera. (Do not use a wet towel.)
D Make sure to turn off the power when you are not recording.
When the LCD monitor is closed, the unit turns off.
When "Quick Restart" is "On", power continues to be consumed for
0
about 5 minutes after closing the LCD monitor screen.
During charging
o
It is recommended to charge the unit in a low humidity environment.
0
The moist air inside the unit can cause condensation.
0
We recommend that you charge the unit in a room where humidifier is not
0
in use, and in an air-conditioned room during summer.
The record settings have changed.
When "Demo Mode" is set to "On", the record settings may reset. Set
0
"Demo Mode" to "Off" for normal use.
" Demo Mode " (A p. 115)
Advertisement
Table of Contents
