Configuring The Camera Settings Appropriate For Your Needs; Configuring The Initial Settings - JVC GV-LS1 User Manual

Configuring the Camera Settings Appropriate for Your Needs

Access the unit from your computer to set the network, streaming, etc.
Required operating environment
Browser: Internet Explorer 9 or later

Configuring the initial settings

To configure the settings for the first time after
purchase, connect the camera directly to your computer
via a LAN cable.
1 Connect the camera to your computer via the
LAN cable. ( ➭ page 25)
2 Press and hold the power button to power on.
The record button starts blinking. Wait until it stops
blinking and off.
3 Configure the network settings for the computer
as follows:
• IP ADDRESS
Other than 192.168.1.100 within the range of
192.168.1.2 to 192.168.1.254
(Example) 192.168.1.23
• SUBNET MASK
255.255.255.0
CAUTION
To restore the settings of your computer after
confirming the performance and completing the
settings, write down the current settings before
changing them.
4 Start Internet Explorer, and enter
"http://192.168.1.100:8000" in the address bar.
5 Enter the user name and password of the
administrator.
Initial setting: USERNAME "root", PASSWORD
"password".
If login is successful, the setup screen appears.
• To configure the settings only to start using the
unit, refer to "Configuring the Camera Settings"
(page 15), "Selecting a Format of Images to
be Streamed/Saved" (page 17), "Allowing You
to Connect from Outside (Monitoring Setting)"
(page 18), and "Changing the Connection
Destination" (page 20).
• To confirm all the settings, refer to "Setting Item
List" (page 39).
13