Konica Minolta bizhub C220 Installation Instructions page 2

7
Remove the tension roller springs
on each side of the assembly.
9
Remove the tension roller by sliding it up and out.
11
Locate the lot code written on the inside of the new belt.
Position the new belt with the lot code facing up.
14. Reassemble all other parts in reverse order.
Note: Prior to re-installing the cleaning blade assembly, apply drum lubricating powder (Katun recommends Kynar powder – Katun part
number 707200) to approximately half the outer belt surface. Install the cleaning blade assembly on to the powdered surface, and then
manually rotate the belt in the normal direction until the powder is cleaned from the belt.
17-04-7551
8
Position the assembly with the handle down
(as shown in the picture).
10
Remove the old belt from the frame.
13
Taking great care not to damage the belt,
slide the new belt onto the frame.