Datalogic Magellan 1100i Product Reference Manual page 69

Global Prefix/Suffix
Global Prefix/Suffix (continued)
START / END
PROGRAMMING BARCODES
Sets up to 20 characters each from the set of ASCII characters or any hex value from 00 to 7F. To configure this fea-
ture, scan the "START/END" barcode above to place the unit in Programming Mode, then the "Set Prefix" or "Set
Suffix," followed by the digits from the Alphanumeric table in Appendix C, representing your desired charac-
ter(s). Reference the section, "Example: Setting a Prefix", for more information. Exit programming mode by
scanning the "START/END" barcode again (scan "START/END" twice if less than 20 characters have been selected).
DEFAULT SETTING PREFIX: 00 (None)
DEFAULT SETTING SUFFIX: 0D (CR)
Set Prefix
Set Suffix
Product Reference Guide 61