Placing Originals In The Optional Adf Or Ardf; Originals Unsuitable For The Optional Adf Or Ardf - Ricoh 2018 Facsimile Reference Manual

Fax option
Hide thumbs Also See for 2018:
Table of Contents

Advertisement

Placing Originals in the
Optional ADF or ARDF
Use the ADF or ARDF to scan in a
stack of originals in one operation.
The ARDF can handle both one-sided
and two-sided originals.
Limitation
❒ Place all the originals to be sent in
a single stack. You cannot place
originals in the ADF or ARDF one
page at a time or in successive
stacks.
Note
❒ To send an original longer then the
following lengths, use Memory
Transmission. However, the maxi-
mum length of an original for
Memory Transmission is 1200 mm
(47").
• A3 or 11"×17" size: 850 mm
(33.5") for Standard, 432 mm
(17") for Detail
1
• B4 JIS or 8
/
mm (39.4") for Standard, 500
mm (19.7") for Detail
1
• A4 or 8
/
"×11" size: 600 mm
2
(23.6") for Detail, 300 mm (11.8")
for Fine
❒ If you frequently send long docu-
ments, set Long Document Trans-
m i s s i o n t o o n w i t h t h e U s e r
Parameters. If a jam occurs, the
document might be damaged be-
cause scanning will not stop. See
p.80 "User Parameters", Facsimile
Reference <Advanced Features>
(switch 14, bit 1).
❒ If your original is bent or folded,
flatten it before you place it.
❒ When sending thin originals, place
them on the exposure glass.
"×14" size: 1000
2
❒ If an original jammed, press the
{ { { { Clear/Stop} } } } key, and then slowly
remove the original.
❒ You can check information about
the sizes and number of originals
that can be placed in the ADF or
ARDF. See p.112 "Acceptable
Types of Originals", Facsimile Ref-
erence <Advanced Features> .
A A A A
Adjust the document guide to
match the size of the originals.
B B B B
Align the edges of the originals
and stack them in the ADF or
ARDF face up.
1.
Limit mark
2.
Document guide
Originals unsuitable for the optional ADF
or ARDF
Do not place the following types of
originals in the ADF or ARDF be-
cause they may be damaged. Place
them on the exposure glass instead.
• Originals in unacceptable sizes
(See p.112 "Acceptable Types of
Originals", Facsimile Reference <Ad-
vanced Features> .)
• Originals containing staples or
clips
• Perforated or torn originals
Placing Originals
2
AAN051S
17

Advertisement

Table of Contents
loading

Table of Contents