Centrifugation; Before A Run; Starting The Centrifugation - Thermo Scientific Medifuge Instructions For Use Manual

7. Centrifugation

CAUT ION
NOT ICE

Before a Run

1� Read and observe the precautions and the safety instructions in this instruction manual�
2� Check the rotor and all accessories for damages such as cracks or scratches�
3� Check the rotor chamber and the centrifuge spindle�
4� Check the rotor suitability�
5� Make sure that the buckets are in correct position�
Set the parameters for the centrifugation� For details:

Starting the Centrifugation

Check the set parameters for the centrifugation, especially when programs are used�
Press the START key� The centrifuge accelerates to the pre-set speed with the time display active�
An animation of a circle is shown while the rotor is spinning�
Thermo Scientific Medifuge Centrifuge
If scraping noises occur, press the STOP key to shut down the
centrifuge. Pull out the power supply plug or disconnect the power
supply in an emergency.
Replace damaged buckets before the next run.
If a bang occurs and the centrifuge starts to shake, a bucket can be
dropped out of its position due to being installed incorrectly.
Press the STOP key to shut down the centrifuge.
Make sure that the bucket is not damaged before using it again.
Install it correctly if it can be used.
„Chemical Compatibility Chart" on page 55
„Control Panel Settings" on page 22
43