CEL-FI PRO Quick Start Manual

Trouble Shooting Guide

The key to better performance is the placement of the two units.
(Error 6) NU Hardware Error (Error 1) Not receiving signal
1. Try resetting the Network Unit 1. Try moving the
by unplugging it and then to another room or area where
plugging it back in. you have more coverage. (Use
2. If the problem persists, return your cell phone to find the best
system for service replacement. cellular signal).
(Error 8) Input signal too strong (Error 4) NU is overheating
1. The signal from the wireless 1. Make sure that the vents on the
network is too strong to use a units are not blocked. Move the
booster. unit to a cooler area. The
system will start working
normally when it cools down.
The units are too close together The units are too far apart
1. Try moving the units farther 1. Try moving the units closer
apart. together.

FCC Requirements:

This is a consumer device.
Before use, you must register this device with your wireless provider and
have your provider's consent. Most wireless providers consent to the use
of signal boosters. Some providers may not consent to the use of this
device on their network. If you are unsure, contact your provider.
You Must operate this device with approved antennas and cables as
speci ed by the manufacturer. Antennas MUST be installed at least 20 cm
(8 inches) from any person.
qsg-PRO-English_14-0212
(Error 6) NU Hardware Error
Network Unit 1. Try resetting the Coverage
Unit by unplugging it and then
plugging it back in.
2. If problem persists, return
system for service.
(Error 3) CU is overheating
1. Make sure that the vents on the
units are not blocked. Move the
unit to a cooler area. The
system will start working
normally when it cools down.
(Error 7) Unit disabled by network
1. Please call your cell
phone provider.
You MUST cease operating this device immediately if requested by the
FCC or a licensed wireless service provider.
WARNING. E911 location information may not be provided or may be
inaccurate for calls served by using this device.
The System and the Outside Antenna (if applicable) must be installed no
higher than 10 meters (32'9") above ground level.
CEL-FI PRO
Quick Start Guide
Box Contents: • 1 Quick Start Guide
• 2 Power Adapters
• 1 Network Unit • 1 Coverage Unit
• 2 Optional Mounting Brackets