Sas And Sata Drive Connections - Supero 4042G-72RF4 User Manual

A+ SERVER 4042G-72RF4 USER'S MANUAL
IPMI LED
The serverboard contains an IPMI LED
(DP1) located near the corner above the
PCI-E slots. When this LED is lit, it means a
connection is active for the built-in IPMI on
the serverboard.
Note: This LED is not installed on non-IPMI
boards.
UID LED (LE1)
A rear UID LED Indicator, located at LE1,
works in conjunction with the rear UID switch
to provide easy identification for a unit that
might be in need of service. Refer to Page
2-13 for further UID details.
5-10 SAS and SATA Drive
Connections
SATA Ports
There are no jumpers to configure the SATA
ports, which are designated SATA0 through
SATA5. See the table on the right for pin
definitions.
SAS Ports
There are eight SAS ports included on the
H8QG7-LN4F serverboard only. See the
table on the right for pin definitions.
Note: JPS1 must be set correctly to enable
the SAS controller.
State
On
Off
Pin # Definition
1
2
3
4
5
6
7
Pin# Definition
1 Ground
3 TXN
5 RXN
7 Ground
5-24
IPMI LED (DP1)
System Status
Active connection
No connection
SATA Ports
Pin Definitions
(SATA0-SATA5)
Ground
TXP
TXN
Ground
RXN
RXP
Ground
SAS Ports
Pin Definitions
(SAS0 ~ SAS
7)
Pin # Definition
2 TXP
4 Ground
6 RXP