Advertisement
(3) Execute
Click "Debug" - "Execute".
(4) If clicking "Debug" - "Stop a program", a program will stop. When executing the program again, click
"Debug" - "Execute".
<Musical Scale Program>
When a program execution starts, LED1(red) lights up. When pressing SW4 on the target board, the
buzzer starts sounding. When pressing SW4 again, the buzzer stops sounding.
<Three-minute Timer>
When a program execution starts, LED1(red) lights up. When pressing SW4 on the target board,
LED3(green) and LED4(green) light up and start counting. The buzzer sounds in three minutes.
When pressing SW1 while counting three minutes, stop counting.
6) Complete High-performance Embedded Workshop
When completing High-performance Embedded Workshop, click "Exit" of File
7) Finally, remove a USB Cable which is connected to the USB port.
25
Advertisement
