NetComm 3G22WV User Manual page 60

NETCO MM LIBERTY
Cal ll Forwarding B Busy
Call forwarding busy will divert all incoming c
To e enable Call Forwardin
(Whe ere directory number
Hang g up after you hear 2

To d disable Call Forwardin

Hang g up after you hear 2

To c check the status of Ca

o
o
Cal ll Forwarding N Not Reachable
Call forwarding busy will divert all incoming c
To e enable Call Forwardin

(Whe ere directory number
Hang g up after you hear 2

To d disable Call Forwardin

To c check the status of Ca

o
o
Con nference Call
This can be achieved by performing a hook-f
Wait t for the third party to answer your call and
Please note e: In order to activate
Tro ubleshooting th he Voice Functio
Wha at do I do if I have no dial tone?
Plea se follow the proced ure listed below:
1. Check to ma ake sure the phone is
2. Check to ma ake sure you are usin
3. Check to ma ake sure the line light
4. Check to ma ake sure the blue 3G
5. Check to ma ake sure your 3G SIM
6. Check and s see if you get the dial
I hav ve noise interference during telephone ca
To re esolve this issue, try t the following:
Verif fy that the RJ-11 cab

Try t to remove any teleph

Try r rebooting your 3G22W

YML L22WVI
www w.netcomm.com
™ SERIES -
calls to a phone numb ber that you desire on
ng Busy, dial *67*<Di irectory Number>#
r is the number you w wish to forward calls t
2 low pitch beeps.
ng Busy, dial #67#
2 high pitch beeps.
all Forwarding Busy, dial *#67# or view th
Call Forwar rding Busy is disable ed if you hear 2 high p
Call Forwar rding Busy is enabled d if you hear 2 low pi
calls to a phone numb ber that you desire on
ng Not Reachable dia al *62*<Directory Num
r is the number you w wish to forward calls t
2 low pitch beeps.
ng Not Reachable, d ial #62#, Hang up aft
all Forwarding Not Re eachable, dial *#62#
Call Forwar rding No Answer is d isabled if you hear 2
Call Forwar rding No Answer is e nabled if you hear 2
lash and then by dia lling the third party.
d then perform anoth her hook-flash to conf
a conference call, yo ou will need to have o
on
s plugged into your 3G G22WV on either Lin
g the correct cable ( Cat-3 UTP Telephone
on the front panel of f the 3G22WV turns s
indication light on the e front of the 3G22W
M card is activated an d insert into your 3G
tone after rebooting your 3G22WV.
alls. How can I fix this s?
le is securely connec cted and not damage
hone splitters from the e connection betwee
WV.
nly if your telephone is busy on another c all.
to)
he advanced status p page of the managem ment console.
pitch beeps.
itch beeps.
nly if your telephone is unreachable by th e network.
mber>#
to)
fter you hear 2 high p pitch beeps.
or view the advance ed status page of the
2 high pitch beeps.
low pitch beeps.
ference all the parties s together.
originated both calls .
e 1 port or Line 2 po rt.
e Cable with RJ-11 p plugs).
solid blue if you lift the e handset.
WV is blinking.
G22WV properly.
ed.
en your phone and the e 3G22WV.
management conso ole.
NetComm 3G2 22WV-I - HSPA+ WiFi Router with Voice Use er Guide
60