NetComm 3G22WV User Manual page 40

NETCO MM LIBERTY
Click the Save button.

NA AT
The NAT page is used to o configure the Netwo
Port Forwarding rules.
This is only needed if you u need to map inbou
How w to configure Port Fo orwarding
OPTION
Item no
Protocol
Source IP Address s
Incoming Port Ran nge
Destination IP Add dress
Destination Port R Range
1. Enter the IP M Mapping configuratio
2. Click Save
Please note: If f the "Incoming Port R
numbers then the "Destination Por
To d delete a port forwardin ng rule, click on the c
YML L22WVI
www w.netcomm.com
™ SERIES -
ork Address Translati on rules currently in use on the router. Th
Figure e 38 ‐ NAT Settings
nd requests to a spe cific port on the WAN N IP address to a dev
Number t to identify the port mapping g. 1 to as many as needed
Specify th he protocol to use for the p port mapping. TCP, UDP, A
Specifies s either a "Friendly" IP addr ress that is allowed to acce
Specify th he external port(s) to listen n to.
Local Are ea Network Address of dev vice to forward inbound req
Local Are ea Network Port(s) to forwa ard connections to.
Table 31 ‐ NAT C Configuration Items
on information as app propriate.
Range" specifies a si ngle port (as above) ) then the destination
rt Range" MUST be th he same as the "Inco oming Port Range".
corresponding "Dele te Entry" link from the e list of IP Mappings
he router is in NAT mo ode by default. The N NAT configuration se
vice connected on th e Ethernet interface, e.g. a web camera.
DEFIN TION
d.
All protocols.
ess the router or a wildcard d IP address of 0.0.0.0 that t allows all IP addresses to
quests to.
port can be set to an ny port. If the "Incom ming Port Range" spe
.
NetComm 3G2 22WV-I - HSPA+ WiFi
ttings are also known n as
access the router.
cifies a range of port t
Router with Voice Use er Guide
40