Table of Contents
Advertisement
(A) AP DISC Input and TO/GA Input are to read the state of the switch. With the switches
not depressed, this line should read Open or Open/High. With the switch depressed, the
respective line should read Low.
(B) Trim Input is to read the direction that the switch is being pressed. With the trim switch
not pressed, this line will show a single dash "-". With the trim switch depressed in the
Nose Down position, this line should read "Nose Down" and with the trim switch
depressed in the Nose Up position, this line should read "Nose Up".
(C) Test Trim Movement is used to verify that the trim moves the correct direction with the
appropriate input. Selecting this line and then selecting Nose Up should cause the trim
to move in the nose up direction. Selecting this line and then selecting Nose Down
should cause the trim to move in the nose down direction..
(D) Annunciations is used to test the GMC 507 annunciators as well as the sonalert output.
Pushing and holding the knob while this row is highlighted will cause all of the mode
annunciators (white arrows above each mode button) on the GMC 507 to illuminate and
the sonalert output to be driven low (causing a tone in the sonalert, if installed) for
approximately one second.
(E) This row is utilized when installing a new GMC 507, or if the G5 has been recalibrated in
Pitch and Roll. Refer to Section 9.1 for further details..
(F) This row is utilized when installing a new GMC 507 to calibrate the GMC 507 if it is not
installed in a panel which is perpendicular to the direction of flight. Refer to Section 9.1
for instructions.
(G) To determine if Expert configuration is utilized for the specific airframe, refer to the
appropriate Install Manual Addendum (190-02291-XX). If Expert Configuration is
required, select the Expert Configuration row and then select OK on the following
screen. This will then display (in amber) the additional fields shown below the Expert
Configuration row in this table. Enter the appropriate values from the Install Manual
Addendum.
(H) Set this field to "Enabled for dual G5 installations.
Set this field to "Disabled" for G5 ADI-only installations that have an external CDI
connected to the navigator.
GFC 500 Autopilot with ESP Part 23 AML STC Maintenance Manual
190-02291-01
Page A-6
Revision 1
Hide quick links:
Advertisement
Table of Contents
