Gfc 500 Software Load And Configuration Procedures - Garmin GFC 500 Maintenance Manual

8. GFC 500 Software Load and Configuration Procedures

8.1 GMC 507 and GSA 28 Software Loading
1. Apply power to the G5/GFC 500 system.
2. On power-up, the GMC 507 and GSA 28 software versions are checked by the system.
If there is a mismatch (due to a replaced unit), the correct software is automatically
loaded to the unit(s) from the G5. Refer to the Garmin G5 Electronic Flight Instrument
Part 23 AML STC Maintenance Manual including ICA, p/n 190-01112-11 if the G5 was
replaced.
8.2 GFC 500 System Configuration
For configuration items not related to the GFC 500 Automatic Flight Control System, refer to the
Garmin G5 Electronic Flight Instrument Part 23 AML STC Maintenance Manual including ICA,
p/n 190-01112-11.
NOTE: The G5 must be configured in accordance with the Garmin G5 Electronic Instrument
Part 23 AML STC Installation Manual prior to configuring the GFC 500 Automatic Flight Control
System.
NOTE: To start the G5 in configuration mode, hold down the knob while powering on the G5.
Configuration selections are made by rotating and pressing the knob on the face of the G5 as
necessary to select the correct configurations. Each configuration item is saved as it is made.
Configure the GFC 500 Autopilot as shown on the aircraft-specific installation manual
addendum (190-02291-XX). Refer to the Master Drawing List 005-01264-00 for the correct
installation manual addendum part number.
GFC 500 Autopilot with ESP Part 23 AML STC Maintenance Manual
190-02291-01
Page 25
Revision 1