Mounting The Device; Desktop Mounting; Figure 4-1: Location Of Grooves For Rubber Feet - AudioCodes Mediant 1000B MSBR Hardware Installation Manual

Hardware Installation Manual
4

Mounting the Device

The device can be mounted in one of the following ways:

Placed on a desk top (see Section

Installed in a standard 19-inch rack (see Section
4.1

Desktop Mounting

The device can be mounted on a desktop by attaching the four anti-slide bumpers
(supplied) to the underside of the device. Once you have attached these bumpers, simply
place it on a desktop in the desired position.

To attach the anti-slide rubber bumpers to the device:
1. Flip the device over so that its underside faces up.
2. Locate the four anti-slide grooves on the underside -- one on each of the four corners.
3. Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove.
4. Flip the device over again so that it rests on its underside and place it in the required
position on a desktop.
MSBR Series

Figure 4-1: Location of Grooves for Rubber Feet

4.1 on page 27)
4.2 on page 28)
27
4. Mounting the Device
Mediant 1000B MSBR