Hardware Installation Manual
4
Mounting the Device
The device can be mounted in one of the following ways:
Placed on a desktop – see Section
Installed in a standard 19-inch rack – see Section
4.1
Desktop Mounting
The device can be placed on a desktop when its four anti-slide bumpers (supplied) are
attached to the underside of the device.
Warning:
Do not place any equipment directly on top of the device.
•
•
The side panels of the chassis, where the air vents are located, must remain
unobstructed to ensure adequate airflow through the chassis. Make sure that
clearance from the ventilation openings is at least 13 cm.
To attach the anti-slide rubber bumpers to the device:
1.
Flip the device over so that its underside faces up.
2.
Locate the four anti-slide grooves on the underside - one in each corner.
3.
Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove.
4.
Flip the device over again so that it rests on the rubber feet and place it in the required
position on a desktop.
MSBR Series
To ensure proper cooling and prevent over-heating of internal components:
Figure 4-1: Location for Applying Rubber Feet
4.1
on page
29
4.2
on page
29
4. Mounting the Device
30
MSBR Series