Mounting The Device; Desktop Mounting; Figure 5-1: Location For Applying Rubber Foot - AudioCodes Mediant 800 MSBR Hardware Installation Manual

Hardware Installation Manual
5

Mounting the Device

The device can be mounted in one of the following ways:
Placed on a desktop – see Section

Installed in a standard 19-inch rack – see Section

Warning:
in a 19-inch rack, ensure that at least a 3U separation is maintained
5.1

Desktop Mounting

The device can be placed on a desktop when its four anti-slide bumpers (supplied) are
attached to the underside of the device.
To attach the anti-slide rubber bumpers to the device:

1. Flip the device over so that its underside faces up.
2. Locate the four anti-slide grooves on the underside - one in each corner.
3.
Peel off the adhesive, anti-slide rubber feet and stick one in each anti-slide groove.
4. Flip the device over again so that it rests on the rubber feet and place it in the required
position on a desktop.
Version 6.6
Do not place any equipment directly on top of the device or adjacent to its
sides (at least 13-cm separation). In addition, if you are mounting the device
between the device and other mounted devices or equipment.

Figure 5-1: Location for Applying Rubber Foot

5.1 on page 23
5.2 on page
23
5. Mounting the Device
24
February 2013