Configuring The Device's Dhcp Server; Configuring The Wan Interface - AudioCodes Mediant 500L MSBR User Manual

5.2

Configuring the Device's DHCP Server

By default, the device's embedded DHCP server is enabled for the LAN, and with default IP
pool addresses relating to the default subnet LAN. You can disable the DHCP server, or
modify the IP address pool. The DHCP server allocates this spool of IP addresses to the
computers connected to its LAN interface.

To enable / disable the device's DHCP server:
1. Establish serial communication with the device.
2. At the prompt, type the following command to access the Data-router configuration
mode:
# configure data
3. Access the data LAN switch interface:
(config-data)# interface vlan 1
4. To disable the DHCP server:
(conf-if-VLAN 1)# no service dhcp
5. To enable DHCP server:
a. Configure the pool of IP addresses:
(conf-if-VLAN 1)# ip dhcp-server network 10.8.6.84 10.8.6.89
255.255.255.0
b. Enable DHCP server functionality:
(conf-if-VLAN 1)# service dhcp
6. Save your settings with a flash burn:
(conf-if-VLAN 1)# do write
5.3

Configuring the WAN Interface

This procedure describes how to configure the WAN interface and uses Gigabit Ethernet
as an example. If you are using a different WAN interface, refer to the CLI Reference
Guide.
Note: Before you configure the WAN interface, make sure that you have all the
required information from your Internet Telephony Service Provider (ITSP).

To configure a WAN IP address:
1. Connect the WAN port to the WAN network. For information on cabling the WAN port,
refer to the Hardware Installation Manual.
2. Establish serial communication with the device.
3. At the prompt, type the following command to access the Data-router configuration
mode:
# configure data
4. Access the WAN interface:
(config-data)# interface GigabitEthernet 0/0
5. Configure the IP address and subnet mask:
(config-if-GE 0/0)# ip address 100.33.2.105
User's Manual 38
Mediant 500L MSBR
255.255.255.0
Document #: LTRT-10466