Acsei-Client Debug Show - 3Com 5500G Configuration And Command Reference Manual

48 Chapter 7: ACSEI Client Configuration Commands on the OSN|M
Parameters
Description
Examples

acsei-client debug show

Syntax
View
Parameters
Description
Examples
None
Use the acsei-client debug enable command to enable debugging for
the ACSEI client.
By default, debugging for the ACSEI client is disabled.
# Enable debugging for the ACSEI client on unit 1.
<SW5500G> osm connect unit 1
Connected to OSM!
[root@localhost ~]# acsei-client debug enable
acsei-client debug show
Any Linux system directory
None
Use the acsei-client debug show command to display the debugging
information about the ACSEI client.
By default, no ACSEI client debugging is displayed.
Note that ACSEI client debugging is displayed through a pipe; therefore,
part of the debugging information may fail to be displayed when the pipe
is full.
# Display ACSEI client debugging information on unit 1.
<SW5500G> osm connect unit 1
Connected to OSM!
[root@localhost ~]# acsei-client debug enable
[root@localhost ~]# acsei-client debug show