3Com 5500G Configuration And Command Reference Manual page 18

18 Chapter 2: Configuring the Application Control Forwarding Protocol (ACFP)
Configure the ACFP client through a MIB browser to send information to
the Switch, where the client index is 1, three working modes are
supported; host, redirect, and mirror (achieved by setting node
h3cAcfpClientMode), the client row status is 4 (achieved by setting node
h3cAcfpClientRowStatus) and the other parameters adopt the default
values.
# Configure the ACFP policy
Configure the ACFP policy through the MIB browser to send information
to the Switch, where the policy index is 1.1, the policy inbound port is
GigabitEthernet 1/0/1 (achieved by setting node h3cacfpPolicyInIfIndex),
the policy destination port is GigabitEthernet 1/1/1 (achieved by setting
node h3cAcfpPolicyDestIfIndex), the policy row status is 4 (achieved by
setting node h3cAcfpPolicyRowStatus) and the other parameters adopt
the default values.
# Configure ACFP rules.
Configure an ACFP rule through a MIB browser to send information to
the Switch, where the rule index is 1.1.1, the action is mirror (achieved
by setting node h3cAcfpRuleAction), matching all packets (achieved by
setting node h3cAcfpRuleAll), the rule row status is 4 (achieved by setting
node h3cAcfpRuleRowStatus) and the other parameters adopt the
default values.
c
CAUTION: When the ACFP policy action is set to mirror, you need to
disable the Spanning Tree Protocol (STP) on the destination port
GigabitEthernet 1/1/1.
Configure an ACFP rule through the MIB browser to send information to
the Switch, where the rule index is 1.1.2, the action is permit (achieved
by setting node h3cAcfpRuleAction), the packets whose source IP address
is in network segment 192.168.1.0 (achieved by setting node
h3cAcfpRuleSrcIP) and source IP wildcard-mask is 0.0.0.255 (achieved by
setting node h3cAcfpRuleSrcIPMask) are matched, the rule row status is 4
(achieved by setting node h3cAcfpRuleRowStatus) and the other
parameters adopt the default values.
Configure an ACFP rule through the MIB browser to send information to
the Switch, where the rule index is 1.1.3, the action is deny (achieved by
setting node h3cAcfpRuleAction), the packets whose source IP address is