C-Type Tool Holder
Tools Needed
To use the C-type tool holder:
1.
2.
3.
Figure 40.
4.
5.
Figure 41
Note: Thread the hex bolt up or down to
make sure the holder top is level and makes
even contact with the tool.
Figure 41.
Qty
Figure 40
Figure 42.
Spindle Speed
The gears, pulleys, and
belts inside the change
gear
cover
severe entanglement haz-
ards. ALWAYS discon-
nect the lathe from power
before opening the change
gear cover.
Figure 42
represent