Grizzly G4000 Owner's Manual page 26

5.
Figure 22
Figure 22.
6.
Figure 23
Note: Refer to ACCESSORIES on Page 43
for test indicator options from Grizzly.
Figure 23.
Always use a low spindle speed when
machining non-concentric or off-center
workpieces to reduce the risk of ejecting the
workpiece from the holding device at a high
rate of speed. Failure to heed this warning
could lead to serious personal injury, death
or property damage.
Faceplate
Figure 24
Figure 24.
NOTICE
You must use a minimum of three inde-
pendent clamping devices when using the
faceplate to hold a workpiece. Refer to
ACCESSORIES on Page 43 for clamping
options from Grizzly.