Flammable Materials; Operating Instructions - Equinox Systems Spark Stream User Manual

Operating instructions

Replacing the fuse:
Only replace the fuse with a fuse of same type and rating.
Before replacing the fuse, disconnect from the mains, see the following for procedure:
Step 1: Open the fuse holder on the rear panel with a suitable screwdriver.
Step 2: Remove the old fuse from the fuse holder.
Step 3: Install the new fuse in the fuse holder.
Step 4: Replace the fuse holder in the housing.
Should you need any spare parts, only use genuine parts.
Should you have any further questions, please contact your dealer.
Air Inlet:
The unit has 1 main air vent on the underside of the unit that is used to keep the machine cool during
operation. Do not cover the unit with anything that may restrict this. To maintain a clear air flow into the
unit, ensure the feet aren't removed and the unit is positioned on a flat surface. Clear any residual dust
that may have built up near the inlet regularly.
Preheating:
The unit has a preheat function on startup. The unit takes approximately 8 minutes to reach the
required temperature to operate.
Granules:
The unit and the granules must be kept dry at all times to ensure safe and successful use. Any unused
granules should be stored in a sealed bag where they cannot be exposed to any moisture. Any granules
that do come into contact with water should be disposed of immediately and must not be used.

Flammable materials:

Whilst the unit and the effect are extremely safe, please do not place any flammable materials within
3m distance of the unit. Please also ensure that the units are not covered with anything that may impact
the flow of sparks during operation.
Transport:
During transport all units should be stored in a flight case or other suitable container with sufficient
padding to ensure no damage occurs during transit.
www.prolight.co.uk Spark Stream User Manual
5