Calling Up The Contact Details For Your Heating Contractor - Viessmann VITODENS Operating Instructions Manual

Scanning information

Calling up the contact details for your heating contractor

Tap the following on-screen buttons:
1. "Menu"
2. "Information"
Resetting operating data (meters)
You can reset the following data to zero:
■ "Burner hours run "
■ "Burner starts"
■ "Solar circuit pump"
"Solar energy"
■
■ "SM1 output 22" (hours run)
"All data"
■
Tap the following on-screen buttons:
1. "Menu"/
Calling up service messages
Your heating contractor can set service intervals (lim-
its) (e.g. for burner hours run). A service message is
generated when this value is exceeded.
If your heating system is due for a service this is indi-
cated on the display with the symbol
Tap on "Confirm".
flashes in the footer.
Calling up a service message
1. Tap on in the footer.
The service message appears in yellow in a list.
Scanning fault messages
If your heating system has developed faults, this is
shown on the display by the symbol
The red fault indicator flashes on the control unit (see
chapter "Starting the heating system").
Tap on "Confirm".
flashes in the footer.
Note
■ If you have connected an alarm to alert you to fault
messages (e.g. a buzzer), this is deactivated when
the fault message is acknowledged.
If troubleshooting cannot be carried out until a later
■
date, the fault message will be displayed again the
following day at 07:00 h. The alarm equipment is
switched on again.
(cont.)
and "Service".
and "Fault".
3. "Service contact details"
Note
If no details have been entered, see page 42.
2. "Information"
3. "Reset data"
4. Select required data point or "All data"
5. OK/ to confirm or
2. Notify your heating contractor.
If your heating system also has fault messages to
display, the following will appear after tapping on
:
"Faults" and "Service messages".
3. Tap on "Service messages"
The service messages appear in yellow in a list.
Note
If the service cannot be carried out until a later
date, the service message will be displayed again
the following Monday.
Calling up a fault message
1. Tap on in the footer.
The fault message appears in red in a list.
Pending service messages appear in yellow.
2. Tapping on ? calls up information on the heating
system characteristics.
Tips on measures you can take yourself before
notifying your heating contractor are displayed.
Calling up information
to cancel
45