Heating circuit selection
The heating of your rooms can be split over several
heating circuits if necessary.
At the factory, heating circuits are designated 1, 2, 3 in
the header.
If you are operating several heating circuits, always
■
first select the heating circuit to which the change
should apply, before adjusting any central heating
settings.
If you are only operating one heating circuit, this
■
option is not available.
Room temperature
Further information can be found in chapter
"Terminology" in the appendix.
Setting the standard room temperature for the selected heating circuit
Factory setting: 20 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Heating circuit 1 2 3" or "Heating circuit 1
in the header for heating circuit selection
Setting the reduced room temperature
Factory setting: 3 °C
Setting range: 3 to 37 °C
Tap the following on-screen buttons:
1. "Menu" or "
"
Repeatedly tap "Heating circuit 1 2 3" or "Heating
circuit 1
" in the header until the required heating
circuit is active.
Fig. 26
HO2B
Fig. 27
HO2C
2. +/
for the required value
–
3. OK/
to confirm
"
2. "Heating"
3. "Heating circuit 1 2 3" or "Heating circuit 1
for the required heating circuit
4. "Reduced room temperature"
Central heating
"
29