Central heating
Room temperature
5. +/
for the required value
–
6. OK/
to confirm
Operating program
Further information can be found in chapter
"Terminology" in the appendix.
Setting the operating program
This is only necessary if "Only DHW"
"Standby mode"
/
Tap the following on-screen buttons:
1. "Heating circuit 1 2 3" or "Heating circuit 1
in the header for heating circuit selection
2.
or
or
The set operating program is highlighted.
Time program
Further information can be found in chapter
"Terminology" in the appendix.
Setting a time program
Factory setting: One time phase from 06:00 to 22:00 h
for every day of the week
1. "Menu"/"
"
2. "Heating"
3. "Heating circuit 1", "Heating circuit 2" or "Heat-
ing circuit 3" as the required heating circuit
Heating curve
Further information can be found in chapter
"Terminology" in the appendix.
30
(cont.)
/
or
is set.
Central heating with this temperature:
■
Between the time phases for central heating at
standard temperature
In the holiday program
■
3. Select "Heating and DHW" to set central heating
4. OK/
to confirm
For information on the operating programs, see
"
page 15.
4. "Time program, heating"
To see how to set a time program, see page 16.
Note
When adjusting the setting, bear in mind that your
heating system requires some time to heat the rooms
to the required temperature.