Lower Bracket To Air Spring Installation - Air Lift 57200 Installation Manual

4. Passenger's (right) side: set the other lower bracket onto the axle making sure the
Passenger's (right) side forward axle view of
finished installation torqued to 10 lb.-ft. (14Nm).

LOWER BRACKET TO AIR SPRING INSTALLATION

All model years will attach in the same way. The late model is being used for the
illustrations.
1. Set a roll plate on top of the lower bracket making sure it is positioned correctly to
10
Insert the long
carriage bolts into the
lower bracket using
the inside set of holes.
Cap with flat washers
and nylon lock nuts.
Make sure the bracket
is against the leaf
spring and in between
the stock U-bolts.
fig. 17
bracket is pushed against the leaf spring and is in between the stock U-bolts. Attach
the lower bracket as shown in the Figs. 12 & 13 instructions noted previously. Torque
hardware evenly to 10 lb.-ft. (14Nm) (Figs. 18 & 19).
nest over the bottom of the air spring. Try to align the holes in the roll plate with the
holes of the lower bracket as closely as possible, then raise the axle up so that the
roll plate just touches the air spring.
fig. 18
Passenger's (right ) side rearward axle view of
finished installation torqued to 10 lb.-ft. (14Nm).
LoadLifter 5000 Series
Carriage bolt (T)
Flat washer (M)
Clamp bar (N)
Nylon lock nut (U)
fig. 19
MN-1044