Finishing The Installation - Air Lift 57200 Installation Manual

LoadLifter 5000 Series
2. Looking below, line up the hole in the roll plate with the air spring and attach using
Flat washer (M or W)

FINISHING THE INSTALLATION

1. For the late-model installations, the ABS line has to be tied together using a zip tie
2. Drop the axle or raise the frame and remove the jack stands.
MN-1044
the 3/8" hex-head bolt (K), lock washer (L) and flat washer (M or W) (Fig. 20). Repeat
for the other mounting hole in the bracket. Since it will be hard to torque this bolt,
unless using a crows foot wrench adapter, just tighten the hardware securely (no
more than 20 lb.-ft. [27Nm] ). Repeat for the other side.
Roll plate (H)
Lock washer (L)
Hex-head bolt
above the bracket so that is does not rub against the air spring (Fig. 21).
Zip tie ABS lines
just above the ABS
bracket so that the
lines clear the air
spring and roll plate.
fig. 20
fig. 21
11