LoadLifter 5000 Ultimate
ATTACHING THE LOWER BRACKET
1. Secure the lower bracket to the axle using the axle straps (M), 3/8" flat washers (I), and
THE BRAKE LINE SITS UNDER THE BRACKET BETWEEN THE CARRIAGE BOLT AND
CAUTION
THE AXLE ON THE INSIDE OF THE RIGHT HAND UNIT . THE OUTSIDE CARRIAGE
BOLT GOES BETWEEN THE BRAKE LINE AND THE AXLE (FIG . 7) .
It may be necessary to re-position the brake line on the right and left hand sides to gain
NOTE
clearance.
2 . Tighten the lock nuts evenly to 16 ft/lbs . Re-torque after 100 miles .
3 . Repeat for the opposite side .
INSTALLING THE HEAT SHIELD
1. Bend the tabs on the heat shield (G) to provide a ½" of space between the exhaust pipe
2. Attach the heat shield to the exhaust pipe using the provided clamps (fig. 9). Bend the
MN-822
3/8" nyloc nuts (H) (fig. 7).
Lower bracket
Brake line
3/8" Flat washer (I)
3/8" Nyloc nut (H)
and the heat shield (fig. 8).
heat shield for maximum clearance to the air spring .
Bend tabs.
fig. 8
The inside carriage bolt
Axle strap (M)
should be outside the
brake line and axle.
Heat shield (G)
The outside carriage
bolt should be between
the brake line and axle.
fig. 7
Exhaust
fig. 9
7