Table of Contents
Advertisement
MCT466-QC User Guide Manual
Chapter 4.
The MCT466-QC NIR Tester is a plug and play device which will be ready for use after being calibrated for
the different products / measured constituents. The built in Smart User Interface makes the end user's job
easier than ever.
4.1. Sitting the Tester
The MCT466-QC NIR Tester is suitable for mounting on a countertop in a laboratory or on a
tabletop at-line in the production environment as shown in Figure 31 below.
4.2.
Temperature
The MCT466-QC NIR Tester is designed to give satisfactory measurements within a temperature
range of 32 to 120 degrees F (0 to 50 degrees C).
4.3. AC Power Connections
The MCT466-QC NIR tester is powered using the 6-foot (2 meters) power cord connected to the
rear of the tester. The input is auto ranging and accepts 90-260VAC volts, 15 amps.
4.4. Communication
The MCT466-QC NIR Tester will communicate with the PC software installed on a remote PC
by using the RS232 port or the USB located on the back of the tester.
Process Sensors Corporation
NIR tester Installation
Figure 31: MCT466 QuikCheck being used in a laboratory environment
Page 28
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MCT466-QC and is the answer not in the manual?
Questions and answers
Hi, we have a model that has not been calibrated since 2022. I **** wondering how often it should be calibrated. As well, is the moisture in dry basis or wet basis?
The document mentions "Calibration Confirmation: Calibration Check Standard" during scheduled plant maintenance but does not specify an exact frequency for calibration. The moisture measurement can be in dry basis mode, as described, where moisture is calculated as a percentage of the dry material rather than the wet material.
This answer is automatically generated