Table of Contents
Advertisement
MCT466-QC User Guide Manual
Page 4 of the diagnostics menu displays the filter values, as shown in Figure 22 below, which are used
to help balance the MCT466-QC NIR tester.
This presents the detector signal levels for the six filters that may be fitted to the filter wheel in the
MCT466-QC NIR tester. Values are given for both external and internal filters. A bar graph
comparison for each filters INT and EXT values may be presented by touching the F# of the filter.
The preamplifier gain value is also presented. This value is an indication of the amplification required
to bring the detector signals into the range required by the processing electronics.
Process Sensors Corporation
Figure 21: Diagnostics Menu – Page 3
Figure 22: Diagnostics Menu – Page 4
Page 20
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MCT466-QC and is the answer not in the manual?
Questions and answers
Hi, we have a model that has not been calibrated since 2022. I **** wondering how often it should be calibrated. As well, is the moisture in dry basis or wet basis?
The document mentions "Calibration Confirmation: Calibration Check Standard" during scheduled plant maintenance but does not specify an exact frequency for calibration. The moisture measurement can be in dry basis mode, as described, where moisture is calculated as a percentage of the dry material rather than the wet material.
This answer is automatically generated