Table of Contents
Advertisement
3.2.6 Calibration Parameters
By touching the calibration parameters button, shown in Figure 13 above, you will
Select Cal page (shown in Figure 15 below). The display will present the product calibrations saved
in the NIR tester.
You can simply select the
right corner to see the calibration parameters for the product being used as shown in Figure
below. Adding a new product is made by touching the NEW blue button.
Process Sensors Corporation
product calibration by touching it. Touch the right arrow on the top
Figure 15: Calibration Parameters Page 1
Figure 16: Calibration Parameters Page 2
MCT466-QC User Guide Manual
access
the
16
Page 15
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MCT466-QC and is the answer not in the manual?
Questions and answers
Hi, we have a model that has not been calibrated since 2022. I **** wondering how often it should be calibrated. As well, is the moisture in dry basis or wet basis?
The document mentions "Calibration Confirmation: Calibration Check Standard" during scheduled plant maintenance but does not specify an exact frequency for calibration. The moisture measurement can be in dry basis mode, as described, where moisture is calculated as a percentage of the dry material rather than the wet material.
This answer is automatically generated