Dispensing Of Hot Water; Dispensing Of Steam - Profitec PRO300 Instruction Manual

Hide thumbs Also See for PRO300:
Table of Contents

Advertisement

Available languages

Available languages

6.4 Dispensing of hot water

1
In case you have not done so yet, activate the steam boiler. Wait until the boiler pressure gauge
indicates a pressure of 1.0 – 1.3 bars.
2
Place a suitable container (with heat-insulated grip) underneath the hot water wand. Now you can
dispense hot water (e.g. for tea) by turning the hot water knob. When dispensing large amounts of water,
it is advisable to turn the machine off so that no cold water is pumped out of the fresh water tank.
3
After having dispensed hot water, turn the machine back on. The boiler is automatically refilled with fresh
water.
Please close the hotwater-/steam –valve gently and do not over tighten it.
We suggest that you empty the water from the steam-/hot water boiler every 2 to 3 weeks.
This makes sure that there is always fresh water in the steam-/hot water boiler.
When the machine is switched off, more hot water can be dispensed.
However, one does not necessarily have to switch off the machine for dispensing hot water.

6.5 Dispensing of steam

The PRO300 makes it possible to generate large amounts of steam in order to heat or froth beverages, e. g.
milk or punch. It is a professional and compact espresso coffee machine. Within a few seconds, you can
prepare milk froth. Please pay attention to the instructions below. Do not bring the milk to a boil, otherwise
frothing milk will not be possible.
1
In case you have not done so yet, activate the steam boiler by the steam switch. The orange control
lamp comes on. Wait a short time until steam has built up in the boiler. The boiler pressure gauge should
indicate a pressure of 1.0 – 1.3 bars.
2
Important: In order to get the best results when frothing milk, open the steamknob for approx.
5 seconds to release the condensation water in the pipe. This also prevents milk from being sucked into
the boiler.
3
Immerse the steam nozzle into the liquid.
4
Turn the steamknob.
5
Heat and/or froth the liquid.
6
After frothing or heating, release the steam into the drip tray to keep the holes of the steam nozzle clean.
Risk of injury
Always keep the steam nozzle underneath the surface of the liquid while heating or frothing in
order to avoid splashing.
Important
After every application, clean the steam nozzle and the steam dispenser with a non-abrasive,
damp cloth. This removes possible liquid residues.
Please close the hotwater-/steam –valve gently and do not over tighten it.
Risk of injury
Avoid skin contact with the steam dispenser while cleaning!
Bedienungsanleitung PRO300 / Instruction manual PRO300
21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pro 300

Table of Contents