GE WattStation Installation And User Manual page 30

4.4.5 Networking tab
This tab is used to configure the network settings of the WattStation.
Enabling Networks and DHCP
•
Note that the wired Ethernet port cannot be disabled. Dynamic Host Control Protocol
(DHCP) tells the WattStation to get IP addresses from DHCP servers if available.
Static IP settings, subnet masks and gateway IPs
•
These settings are used if DCHP functionality is disabled, or if a DHCP server is not found.
Primary and Alternate DNS
•
These have been defaulted the popular Google DNS servers, but can be changed as
desired.
Routing Table settings
•
This is advance functionality for network specialists. These settings are used to add or
delete entries to the routing table as follows:
© GE All Rights Reserved
30