GE WattStation Installation And User Manual page 20

After saving settings reboot the computer or otherwise verify that its IP settings have changed.
Connect the computer's Ethernet port to the WattStation's external Ethernet port with a Cat5
cable. Connection to the configuration tool can now be made by typing the following into the
browser's URL window.
Type into URL window: https://192.168.13.1
The web browser will likely respond with a screen questioning the security of the WattStation's
https server. This is fine and to be expected (see Section 4.3 – Accepting Connection to the
Configuration Tool).
Approach 2:
If the WattStation does have the cellular router option, the cellular router does have an internal
DHCP server and will provide any DCHP clients connected to it IP addresses starting with
192.168.13.100. This makes determining the IP address of the WattStation more complex, since
multiple WattStations may be connected in addition to the computing device you are using to
browse into the configuration tool. In this case, you should start by trying to log into the tool at
192.168.13.100 and increment the last byte (i.e. 100 -> 101, 102, 103, etc.) of the IP address until all
WattStation units are configured. Note that your computer may be one of these addresses and
unless you happen to be running an HTTP or HTTPs server on it your browser should respond that
it could not connect.
Type into URL window: https://192.168.13.100
Your browser will likely respond with a screen questioning the security of the WattStation's https
server. This is fine and to be expected (see section 4.3– Accepting Connection to the Configuration
Tool).
20
© GE All Rights Reserved