GE WattStation Installation And User Manual page 24

From this screen you can select from one of the following options.
Configuration settings tab:
•
Diagnostics tab:
•
Factory Defaults tab:
•
Log File tab:
•
Network Troubleshooting tab:
•
Logout tab:
•
IMPORTANT!
For configuration changes to take effect, the changes must be saved to the configuration file.
This happens on a page by page basis when the submit button is pressed.
In some instances, power to the EVSE must be cycled for the changes in the configuration file to
be implemented. The instruction in blue at the top of each configuration page will indicate
whether or not a power cycle is required to make configuration changes take effect.
© GE All Rights Reserved
o Common ................. a variety of settings to configure WattStation functionality
o Authorization ......... settings to configure access control and payment options
o GE Connect ™ ....... settings to configure your WattStation location and time zone
o Modbus .................... settings to configure Modbus networking options
o Network ................... settings to configure your networking and WiFi security options
o Device Info .............. this tab shows a complete list of all the current configuration
settings.
o Troubleshooting information (e.g. fault codes) which are also described in Section 8
of this manual.
o This tab provides for the option of restoring the configuration settings back to their
factory default settings.
o Reserved for the creation and capture of a diagnostic log file
o Provides a number of diagnostic commands useful for network setup and for
diagnostics of wired and wireless network problems:
Ifconfig – information such as IP address and MAC address for each port
Iwlist – scans for available WiFi signals and displays results
ping – can be used to test connection to other IP addresses
route – shows the contents of the routing tables
o Don't forget to logout before exiting your browser as the configuration tool
restricts usage to one logged in user at a time. If you try to login and get a
message that someone else is currently logged in and if you are certain that the
last user just forgot to logout, simply wait one minute and then try to login again.
24