GE WattStation Installation And User Manual page 26

Start Charging Delay after Power-up
•
If a car is connected and authorized and power is lost, when power is restored it will start
charging again automatically. This setting inserts a random delay from 0 to the value
selected in the start-up time after power is restored. A setting of 0 means no delay.
Station, Group and Locality IDs
•
These are optional settings that Owner/Operators can use to specifically identify their
WattStations. For example, a WattStation could be identified as Station number 4 in Group
(e.g. parking facility) number 3 in Locality (e.g. city) number 5.
4.4.2 Authorization tab
WattStation can be configured for any of four (4) Authorization Modes:
1. Free Access mode ............................................................ always ready to charge
2. RFID Access mode ............................................................ available with RFID option only
3. Payment by Mobile Application mode .................. use QR code (see Section 3.1.14)
4. Payment by RFID mode ................................................ available with RFID option only
Follow the rules in the table below to configure the WattStation for each of these modes. The
normal "not-in-use" icon will be illuminated as shown according to the authorization mode.
Authorization Mode
1. Free Access mode
2. RFID Access mode
3. Payment by Mobile
App mode
4. Payment by RFID
mode
IMPORTANT!
Authorization Mode 4 is the only way to enable "Payment by RFID mode".
However, Authorization Modes 2 and 3 are also possible in Authorization Mode 4.
Therefore, WattStation owners must use their WattStation Connect™ accounts to select
whether RFID Access mode and/or Payment by Mobile Application mode are enabled for
Authorization Mode 4.
WattStation Connect™ can determine based on the RFID card type whether it is an access
type card or a payment type card.
© GE All Rights Reserved
Authorization RFID Installed
Required but Disabled
26
Payment
Transaction
Required