Ip Address Reset Feature - GE WattStation Installation And User Manual

4.2 IP Address Reset Feature

If you assign a static IP address to the WattStation unit be sure to write this address down and
store it in a safe place. If, however, you should happen to forget the station's IP address there is a
jumper plug provided that will allow you to reset the IP address to the factory default setting
(192.168.13.1). This jumper plug is located inside the enclosure of the charging station. To access
this harness you must remove the front cover and the dead front. Refer to the methodology of
Section 2.3.2 for instructions on how to do this.
WARNING:
gaining access to the unit.
After removing the front cover and the dead front, the jumper plug can be found on the upper-left
hand side of the plastic enclosure. Insert the jumper plug into header J11 on the top circuit board,
then replace the dead front and front cover and power up the unit.
The fault icon will flash RED when the jumper is connected to the J11 header.
After the IP address is reset, the customer must power down the EVSE, remove the jumper cable,
and reboot.
© GE All Rights Reserved
The customer must remove power to the EVSE before
IP reset harness is located on the upper-left side of the enclosure
21