Hellenbrand PM6 IC Storm 10 Manual page 13

ITEM NO.
ORDER NO.
1 101325
.
NOTE: Individual Bypass Components Are Not Available, Must Order
Complete Bypass Assembly.
ITEM NO.
ORDER NO.
Not Shown 101172
1 102141
2 102437
3 102165
11* 101172
*11 (Not Shown)
The nuts and caps are designed to be unscrewed or tightened by hand or
with the special plastic wrench. If necessary a pliers can be used to un-
screw the nut or cap. Do not use a pipe wrench to tighten or loosen nuts or
caps. Do not place screwdriver in slots on caps and/or tap with a hammer.
Do not use pipe dope or other sealants on threads. Teflon tape must be
used on threads of the 1" NPT connection and on the threads for the drain
line connection. Teflon tape is not necessary on the nut connection nor
caps because of o-rings seals.
Although no tools are necessary to assemble or disassemble
the valve, the wrench (shown in various positions on the
valve) may be purchased to aid in assembly or disassembly.
102892 - Wrench
13
BYPASS VALVE
DESCRIPTION
Complete Bypass Assembly
DESCRIPTION
Bypass 90º Vert. Assy.
Nut 1" Quick Connect
Split Ring
O-Ring 215
Bypass Vertical Adpt. Assy.
QTY.
QTY.
2
2
2
2
WRENCH
Figure 14