Front Cover And Drive Assembly - Hellenbrand PM6 IC Storm 10 Manual

Promate-6.0 iron curtain storm series

Hide thumbs

Table Of Contents

Table of Contents

ITEM NO.

ORDER NO.

103473

102096

101262

109807

101746

101459

103724

102385

110038

Not Shown

110409

After completing any valve maintenance involving the drive assembly or the drive cap assembly and pistons,

press and hold NEXT and REGEN buttons for 3 seconds or unplug power source jack from the printed

circuit board (black wire) and plug back in. This resets the electronics and establishes the service piston

position. The display should flash all wording, then flash the software version (ex: 214) and then reset the

valve to the service position.

DRIVE CAP ASSEMBLY, DOWNFLOW PISTON, REGENERANT PISTON

ITEM NO.

ORDER NO.

102548

101613

102167

102292

102297

102296

102192

102165

101189

102892

*102292 is labeled with DN and 102297 is labeled with UP.

Note: The regenerant piston is not used in backwash only applications.

**Standard Option.

Do not use vaseline, oils, other hydrocarbon lubricants or spray silicone anywhere. A silicone lubricant may be used on black o-rings but is not necessary. Avoid

any type of lubricants, including silicone, on red or clear lip seals.

After completing any valve maintenance involving the drive assembly or the drive cap assembly and pistons, press and hold NEXT and REGEN buttons for 3 seconds

or unplug power source jack from the printed circuit board (black wire) and plug back in. This resets the electronics and establishes the service piston position.

The display should flash all wording, then flash the software version (ex: 214) and then reset the valve to the service position.