Advertisement
Available languages
Available languages
Connect
Hose
and Water
Supply
to Pump
IMPORTANT: To avoid pump damage, you must
assemble the nozzle extension to the spray gun and
attach all hoses before you start the engine.
1. Uncoil high pressure hose and attach one end of
hose to base of spray gun. Tighten by hand.
6.
Connect garden hose (not to exceed 50 feet in
length) to water inlet. Tighten by hand.
this instruction willvoid warranty
7.
Turn ON water and squeeze trigger on spray gun
to purge pump system of air and impurities.
WARNING
2. Remove and discard shipping caps from pump inlet
and outlet.
3. Attach other end of high pressure hose to high
pressure outlet on pump. Tighten by hand.
Inspect inlet ........
screen. DO NOT
use if damaged;
wearing adequate eye protection.
clean if dirty.
............... CHECKLIST
BEFORE STARTING
ENGINE
Review the unit to ensure you have performed all of
the following:
1.
Make sure handle is in place and secure.
2.
Check that oil has been added to proper level in
engine crankcase.
3.
Add proper fuel to fuel tank.
4.
Before connecting garden hose to water inlet,
inspect inlet screen. Clean screen if it contains
debris or have it replaced if damaged. DO NOT
run pressure washer if inlet screen is damaged.
5.
Run water through garden hose for 30 seconds to
flush it of debris. Turn off water.
IMPORTANT:
DO NOT siphon standing water for the
water supply. Use ONLY cold water (less than 100=F).
4.
Check for proper hose connections (high pressure
and water supply) and that there are no kinks,
cuts, or damage to the high pressure hose.
5.
Provide proper water supply (not to exceed
100°F).
6.
Be sure to read "Safety Rules" and "Operation"
sections before using the cleaning system.
8
Advertisement
