Advertisement
Available languages
Available languages
HOW TO USE YOUR CLEANING
SYSTEM
If you have any problems operating your pressure
washer, please call the pressure washer helpline at
1-800-222-3136.
To Start Your Cleaning
System
To start your engine-powered
cleaning system for the
first time, follow these instructions step-by-step. This
information also applies whenever you start the engine
after you have let the pressure washer sit idle for at
least a day.
1.
Place pressure washer near an outside water
source capable of supplying water at a flow rate
greater than 3.0 gallons per minute and no less
than 20 PSI at pressure washer end of garden
hose.
._.,._
Safety Latch
10. Move throttle lever to "Fast "_position, shown here
as a rabbit.
2.
Check that high pressure hose is tightly connected
..........................................
>
t'
to spray gun and pump. See "Assembling Your
Pressure Washer" for illustrations.
3.
Make sure unit is in a level position.
4.
Connect garden hose to water inlet on pressure
washer pump. Turn ON water.
this instruction.
5.
Squeeze trigger on gun to purge pump system of
air and impurities.
6.
Place quick connect spray tips in slots on holder
attached to nozzle extension.
11. Move choke lever to "Choke" position.
NOTE: For a warm engine, be sure the choke lever is
in the 'Run" position.
12. Grasp handle and pull recoil starter lightly until you
feel some resistance, then pull briskly.
13. Return recoil starter slowly. DO NOT let rope
"snap back" against starter.
14. When engine starts, slowly move choke lever to
"Run" position, as engine warms. If engine falters,
move choke lever to "Choke" position, then to
"Run" position.
15. If engine fires, but does not continue to run,
squeeze trigger on spray gun to relieve internal
pump pressure. Move choke lever to "Run"
position, and repeat steps 12 through 14.
16. If engine fails to start after six pulls, move choke
lever to "Run" position, and repeat steps
12 through 14.
7.
Attach nozzle extension to spray gun. Tighten by
hand.
8.
Choose desired spray tip and insert into nozzle
extension. See "How to Use Spray Tips".
9.
Engage safety latch to spray gun trigger.
NOTE: Always keep the throttle lever in the "Fast"
position when operating the pressure washer.
9
Advertisement
