Advertisement
Available languages
Available languages
Service Air Cleaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements
are available at your local
Sears service center.
To service the air cleaner, follow these steps:
1.
Loosen two screws and lift off cover.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug if the electrodes are worn, or if
the insulator is cracked or chipped.
4.
For replacement use either the standard resistor
spark plug, Champion RC12YC or the long life
platinum spark plug, Champion RC12PYP.
5.
Check electrode gap with wire feeler gauge and
set gap at 0.020 inches (0.50ram), if necessary.
Two Screws
Cover
Cartridge
Base_
2.
Carefully remove air cleaner from base.
3.
To clean cartridge, gently tap pleated paper side
on a flat surface.
4.
Install clean (or new) air cleaner in base. Air
cleaner must fit securely in base.
5.
Place cover over air cleaner and tighten screws.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.
Service
Spark
Plug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
WARNING
6.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.
Carburetor
If you think your carburetor needs adjusting, see your
nearest Sears service center. Engine performance
may be affected at altitudes above 3000 feet. For
operation at higher elevations, contact your nearest
Sears service center.
Spark
Arrester
Service
Your engine is not factory-equipped
with a spark
arrester. In some areas, it is illegal to operate an
engine without a spark arrester. Check local laws and
regulations. A spark arrester is available from your
nearest Sears service center. If you need to order a
spark arrester, please call 1-800-366-PART.
The spark arrester must be serviced every 50 hours to
keep it functioning as designed.
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing the
spark arrester.
Remove spark arrester screen for cleaning and
inspection.
Replace if screen is damaged.
15
Advertisement
