Advertisement
Available languages
Available languages
Yourcleaning system requires some
assembly and is
ready for use only after it has been properly serviced
with the recommended oil and fuel.
If you have any problems with the assembly of
your pressure washer, please call the pressure
washer helpline at 1-800-222-3t 36.
IMPORTANT:
Any attempt to run the engine before it
has been serviced with the recommended
oil will result
in an engine failure.
REMOVE
PRESSURE
WASHER
FROM CARTON
1.
2.
3.
4.
5.
Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
Remove hose reel box, fillers, and parts bag
shipped with cleaning system.
Remove spray gun, nozzle extension, and engine
oil from fillers.
Roll cleaning system out open end of carton.
Check carton for additional loose parts.
CARTON
CONTENTS
Check all contents. If any parts are missing or damaged,
call the pressure washer helpline at 1-800-222-3t 36.
Main Unit
Handle
Hose Reel Components
Chemical Reservoir Assembly
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting and
Tip Holder
Oil Bottle
Parts Bag (which includes the following):
Owner's Manual
Owner's Registration Card
Bag containing 4 multi-colored
Quick Connect
Spray Tips
Handle Fastening Hardware Kit (which includes):
Carriage Bolts (2)
Plastic Knobs (2)
"L_ Bolt
Plastic Knob
Become familiar with each piece before assembling
the pressure washer. Identify all contents with the
illustration on page 5. If any parts are missing or
damaged, call the pressure washer helpline at
1-800-222-3136.
ASSEMBLING
CLEANING
SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1.
Attach handle to main unit.
2.
Connect chemical hose to pump.
3.
Attach hose reel to handle as shown on page 5
according to instruction sheet included with hose
reel.
4.
Add oil to engine crankcase.
5.
Add fuel to fuel tank.
6.
Connect high pressure hose to spray gun and
pump.
7.
Connect water supply to pump.
8.
Attach nozzle extension to spray gun.
9.
Select/attach quick connect spray tip to nozzle
extension.
Attach
Handle
1.
Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
Align Holes_
Handle
Supports
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2.
Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit.
Tighten by hand.
.
Insert "L" bolt through hole just above billboard on
right side of handle (viewing from rear of unit).
Hold hook in place and attach plastic knob from
inside of unit. Tighten by hand.
' Gun
Hook
NOTE: If lecknut is provided in place of plastic knob,
hold hook in place with pliers and attach Iocknut with
7/16" wrench.
6
Advertisement
