Safety Precautions - Raytech MC2 Instruction Manual

200 amp digital micro-ohm meter
Table of Contents

Advertisement

SAFETY PRECAUTIONS!

The following safety precautions must be observed during all phases of operation, service, and
repair of this instrument. By purchasing this equipment the purchaser assumes all liability for the
operation and use of this equipment. The intended use of the instrument, its design and
manufacture, is to be conducted within the precautions or other specific warnings located within
this manual. Failure to comply with these precautions and other specific warnings violates safety
standards of design, manufacture, and intended use. Raytech USA, Inc. assumes no liability for
the operation and use of this equipment.
SAFE OPERATION
Only qualified knowledgeable persons should be permitted or attempt to operate this test
equipment. All test personnel should fully familiarize themselves with the correct application and
operation of this and all test equipment prior to operation. Persons directly and indirectly
engaged in the operation of this test equipment should keep clear of all high voltage apparatus
while conducting tests and measurements.
BEFORE APPLYING POWER
Read this manual carefully before operating the system.
The MC2 is line operated. The system operates from an auto-sense input power from the main
power input from 100 to 250 vac 50/60Hz.
DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE
Do not operate the instrument in the presence of flammable gases or fumes.
KEEP AWAY FROM LIVE CIRCUITS
Operating personnel must not remove instrument covers. Component replacement and internal
repairs must be made by qualified service personnel. Do not replace components with power
cable connected. To avoid injuries, always disconnect power, discharge circuits, and remove
external voltage sources before touching components.
DO NOT SUBSTITUTE PARTS OR MODIFY INSTRUMENT
Because of the danger of introducing additional hazards, do not install substitute parts or perform
any unauthorized modification to the instrument. Return the instrument to a Raytech USA
service department for service to ensure proper operation and that safety features are maintained.
Instruments, which appear damaged or defective, should be made inoperative and secured against
unintended operation until they can be repaired by qualified service personnel.
TEST WARNINGS!
1. Do not use on live circuits.
2. Do not use a faulty or under-powered Generator or
Inverter to power the system.
3. Do not vary the input mains voltage or frequency while operating.
4. The system is not intended for the testing of
Inductive loads (transformers).
Raytech USA, Inc. All rights reserved
1 – 0
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MC2 and is the answer not in the manual?

Questions and answers

Table of Contents