Section 9
Read and change settings
9.2.6
9.2.6.1
9.2.6.2
9.2.6.3
9.2.6.4
42
Logic rotating switch SLGGIO
Main menu/Settings/General settings/Control/Commands/
SelectorSwitch(GGIO)/SLGGIO:x
A number of selector switches SLGGIO can be configured in the system. These are
substitutes for rotating physical switches. The parameter setting StopAt Extremesis
used to disable or enable the end position of the switch.
Versatile switch VSGGIO
Main menu/Settings/General settings/Control/Commands/VersatileSwitch/
VSGGIO:x
Parameters such as control model according to IEC61850 and operation mode for
the versatile switch is set here.
Monitoring
Overview
Under monitoring there are parameters for setting Service values, current phasors,
Voltage phasors, Disturbance reports and the Measured value expander block.
Service values CVMMXN
Main menu/Settings/General Settings/Monitoring/ServiceValues(MMXN)/
CVMMXN:x
Displays available instances of CVMMXN.
Current phasors CMMXU
Main menu/Settings/General Settings/Monitoring/CurrentPhasors(MMXU)/
CMMXU:x
Displays available instances of the current phasor function CMMXU with output
regarding current amplitude, current range, phase angle, zero sequence current
magnitude and negative sequence current magnitude.
Voltage phasors VMMXU/VNMMXU
Main menu/Settings/General Settings/Monitoring/VoltagePhasors(MMXU)/
Phase-Phase/VMMXU:x
Displays available instances of the voltage phasor function VMMXU with output
data for phase to phase voltage, (amplitude, phase angle). The setting parameters
for supervision levels, deadband etc. are set here
1MRK511251-UEN B
Operator's manual