Section 11
Test the IED
11.6.6.2
11.6.6.3
11.6.7
60
Commands
In the commands menu it is possible to view three sets of values. These are found
under the submenus menucascade/uicontrol.
Automation bits, command function for DNP3.0 AutomationBits
Main menu/Test/Function status/Control/Commands/Automation Bits/
AUTOBITS:x
Displays the output data of the AutomationBits function.
Single command SINGLECMD
Main menu/Test/Function status/Control/Commands/SingleCommand/
SINGLECMD:x
There are OUT signals under the Single command menu.
Selector switch SLGGIO
Main menu/Test/Function status/Control/Commands/SelectorSwitch(GGIO)/
SLGGIO:x
An application dependent number of switches can be displayed here. The position
of each switch is indicated here. There are up to a number of possible switch
positions. The number of switches and switch positions is determined by the
configuration in the PCM configuration tool.
Selector mini switch VSGGIO
Main menu/Test/Function status/Control/Commands/VersatileSwitch/
VSGGIO:x
Displays the output data of the VSGGIO function.
IEC61850 generic communication I/O functions DPGGIO
Main menu/Test/Function status/Control/DoubelPointIndication(DPGGIO)/
DPGGIO:x
Displays the output data of the DPGGIO function.
Monitoring
Monitoring includes large amounts of viewable data including Disturbance report
data, Service values, Current phasors, Voltage phasors, Milliampere signal level
supervision, Binary signal status report, Events, MVGGIO, MVExpander and LEDs.
1MRK511251-UEN B
Operator's manual