Analog And I/O Modules; Overview; Analog Modules; I/O Modules - ABB Relion RES670 Operator's Manual

1MRK511251-UEN B
9.2.3
9.2.3.1
9.2.3.2
9.2.3.3
Operator's manual
Main menu/Settings/General settings/Communication/Ethernet configuration/
Rear OEM-Port CD
The IP address (with different IP address when a second channel is used), IP mask
and Mode for the Optical Ethernet Module (OEM) at the rear of the IED are set here.
Main menu/Settings/General settings/Communication/Ethernet configuration/
Rear OEM - Redundant PRP
Redundant station bus communication IEC61850-8-1 are set here.
Main menu/Settings/General settings/Communication/Ethernet configuration/
Gateway
If a gateway is used to access the system the address to that gateway is entered here.

Analog and I/O modules

Overview

Under Analog modules in the General settings menu there are settings for Analog
inputs and I/O modules. Within each instance of analog input there are settings for
all 12 channels that include the name of the channel, star point of the CT circuit,
the primary and secondary values from the measuring transformers . The channel
type and ratings are shown but cannot be changed.
The settings for binary inputs and outputs even include the milliampere input
modules. A mix of up to 14 instances of BIM, BOM and IOM is possible
depending on the physical configuration of the IED. Operation ON or OFF can be
set for all of these and for the BIMs oscillation release and oscillation block
settings are available. These settings are on board level and apply to all binary
inputs or outputs on a board.

Analog modules

Main menu/Settings/General Settings/Analog modules/AnalogInputs
Main menu/Setting/General Settings/Analog modules/
3phAnalogSummationGroup/3PHSUM:x
Here is where the settings for the summation block are done. The summation type,
Fourier filter reference frequency are some of the parameters that can be set here.
Settings/General Settings/Analog modules/Reference channel service values
The phase angle reference is set here.

I/O modules

Read and change settings
Section 9
39